Osage static, 55#/28″ (No. 47)

post image

This bow is asymmetrical with a positive tiller of about 7 mm. Limbs are dead flat on belly, on the back a shallow crown. The fades are 6” long (widest part of limb – to handle). String groove filed into the levers. It was a nice clean stave, only two pin knots with no problems.Read more

Elm static 45#/28″ (No. 41)

post image

This bow came from a very nice and clean elm stave. Only some side corrections were necessary, done with the heatgun. Tips are horn overlays from water buff. The bow is 62”ntn.  Read more

Osage sinewed static for Kare, 51#/28″ (No. 40)

post image

This bow was a birthday present for my good friend Kare. Sinew backing is done in 2 layers. Levers are strengthened with  horn wedges, string bridges is leather (+ super glue). The string bridges are lather soaked in thin super glue after applying. I make those bridges often on statics, reasons: 1. more security whileRead more

bow/quiver/arrow set for my wife 40#/28″ (No. 27)

post image

Bow: osage static recurve. Limbs have a lenticular cross section, widest part of the limbs are exactly midlimb. No heat treating, but some heat corrections. Levers are 45° reinforced with inserted horn wedge, recurve kink reinforced with horn underlay (steamed), overlay also water buffalo horn, string bridge is leather reinforced with thin super glue. VeryRead more

Elm west coast 53#/26″ (No. 17)

post image

elm heartwood, ntn 49″ bending handle, buckskin wrapping painted with natural pigments two layers sinew, wrapped at handle and below tips (red ) w/d: handle: 32/18 mm fade (3″): 48/14 mm midlimb: 50/11 mm below string kerf: 18/8 mm    Read more

osage static recurve from junk 63#/29″, (No. 11)

post image

This piece of osage was laying around in my shop for years. It was a leftover from a regular stave, very thin in the middle (handle) and lot of deep cracks. there are also several groups of pin knots to manage. Some time ago I decided to give it a try. Steamed the recurves in,Read more

Osage hunting bow, HLD, 85#/26″ (No. 8)

post image

Here is an osage hunting bow with static recurves and hollow limb design.The stave was a nice coloured piece with some areas of several pin knots, but still holding up so far without problems. Recurves are steam bent, selfnocks no overlay, handle buckskin leather, bends slightly in the handle. Simple stick. cross section is likeRead more

Osage static recurve 47#/28″ (Nr. 1)

post image

This osage has a big curve in the upper limb, coming from a dead branch. Cross section is nearly rectangle from fades to midlimb then tapers into a stacked belly until it reaches the stringbridge. The levers have an almost triangular cross section, or more like a T.  Inlays, overlays and arrowpass are buffalo horn.Read more

1 2 3 4